08-09-2006, 12:06 PM
|
|
Junior Member
|
|
Join Date: Aug 2006
Posts: 1
|
|
Radiator rubber blocks--which where?
Just replaced the thermostat in my '88 924S. Decided to back
flush the radiator since I was close. When I pulled the
radiator all four of the rubber mounting blocks came out. There
are two different thicknesses. Which goes up top, and which is
at the bottom?
Thanks,
Craig
BTW the thermostat was broken at the top of the brass bridge
that holds the spring shaft. There's a little pressed-in
bushing.
The thing broke on either side of that. Don't know where the
bushing went. That was another incentive to flush the radiator.
|
Linear Mode
